Lightburn Camera Mount for Ortur & X-Tool D1 (STL File)

What is it? A 3d printable STL file that you can print for attaching a Lightburn camera mount (made of aluminum v slot rails) to the back of your Ortur Laser Master (2 & pro) Laser.

It will also work with the XTool D1 & XTool D1 Pro - IF you DRILL holes through the rear frame. However, if your spoilboard extends about an inch and a half beyond the rear of the Pro frame, the mount has a hole on the bottom to secure it to the spoilboard for extra security.

ALSO - you can modify the STL file FOR YOUR OWN USE (NOT TO BE SOLD OR GIVEN AWAY). The only part file included here is the one circled in RED. HOWEVER - I have links to the other parts you will need below to assemble EXACTLY what I have made in the photographs. (I didn't want an all-plastic frame because I felt it wasn't solid enough).

• This accommodates the SOLID aluminum rails and hardware. How it works: The bottom of the mount is open. So, the v slot rail slips into the mount & rests on the spoilboard. It can be screwed down to make it solid. It is attached using up to size M5 screws & drop in T nuts to the back of the laser frame (see photos). I designed it and am using it with the v slot rails linked below. Tolerances vary depending on your printer. But I printed it using 0.20 layer, no supports, on a Prusa MK3S+. My result was very secure yet slides in easily.
• I also have a hole built in if you wanted to screw in an M5 bolt/screw to tighten up the vertical rail. **IF your laser's feet are sitting on top of holders that are attached to the spoilboard, you may need to add a spacer - or washer under this printable mount in order to screw it to your spoilboard.
• The distance of the bottom of this part to the center of the screw holes that go into the rear laser rail is 47mm.
• There is a link down below for the exact feet I used to mount my laser so you can print those too - which will put your laser exactly the right spot as I have designed here.
• ALSO - you have this file - so you can move the holes/add holes if you need to!! Just don't sell my design - even if you "re-make it".
• Once you pay, you will get fast access from Etsy to download the file. It will come as a ZIP file. Open that - and then the STL will be within for use.
• I designed this and it is protected by copyright rules and cannot be reproduced & re-sold; do not share; do not create and sell this item. You can, however, modify it for your own use. If you have questions, please ask. Thank you.
• REQUIRED ADDITIONAL PARTS TO MAKE THE CAMERA MOUNT (these are the exact items I used for my setup. You will end up with more than you need - but these parts are useful for 3d printing AND lasering if you are into both!!): 2020 v slot rails; https://amzn.to/3vJwUeW Drop In T nuts: https://amzn.to/3tSrwUj Outside Joining Plates: https://amzn.to/3IPoyWP Printable Stackable Laser Master Feet: https://www.thingiverse.com/thing:4979137 (NOTE_ you can find some of the above parts available on Thingiverse that you can 3d print out & save some $$ - but it won't be as solid).
• PURCHASE & USE LIMITATIONS AGREEMENT When you purchase this item, you are agreeing to comply with the following: 1. You may 3d print this adapter for your personal use only. 2. You may NOT print this adapter and re-sell it. 3. You may NOT share the files for free. 4. You may NOT sell the files. 5. You may NOT post the files, upload, nor send them anywhere that someone else will be able to utilize them (websites, social media, email, messaging, Air Drop, etc.).